Cannabis Medicine at home by Nugs & Nurse Tori

Some folks prefer to use fractionated coconut oil or “MCToil” (liquid coconut oil) for their infusions. Simply put, the primary difference between “MCT oil” and unrefined coconut oil, is the “MCT oil” is processed to remove the MCFA Lauric acid. Isolated Lauric acid has a melting temperature of 100 degrees F, this is why raw coconut oil is a solid fat at room temperature, whereas “MCT Oil” (with the Lauric acid removed) is a liquid at room temperature. Raw coconut oil is comprised of up to 50% of this amazing fatty acid that has many health benefits on its own. The principle reason for the food and cosmetic industry to isolate and remove Lauric acid from raw coconut oil is to use it as an ingredient in dietary supplements, drugs, detergents and cosmetics. The “MCT oil” is a by-product from the process of isolating Lauric acid from pure coconut oil. Though “MCT oil” still contains a considerable amount of MCFA’s, it is missing what many believe to be the most beneficial medium chain fatty acid of them all (Lauric acid). Raw coconut oil contains the highest concentration of MCFA’s and Lauric acid on Earth.

The next highest natural concentration of Lauric acid isin human breast milk, at around 6% by volume! (Remember, coconut oil is 50%) It is a natural anti-fungal, anti-bacterial, anti-viral and an immune system regulator and supporter. Lauric acid is also known to reduce blood cholesterol levels reducing the risk of heart disease. It is no wonder that populations who consume a LOT of coconuts and the oil from them are some of the healthiest on the planet. When assisting those with a Cannabis Medicine protocol such as weak immune systems, compromised liver function, and/or gastrointestinal issues becomes commonplace, it only makes good sense to utilize this wonderful fatty acid in its natural unadulterated state.

The following recipe makes a wonderfully pure infusion suitable for oral ingestion straight out of the jar. Averaging 50% overall decarboxylation the oil can be used “as is” or be used in making baked goods and other Cannabis edibles. When used in baked goods the oven temperatures will completely finish the decarboxylation process for those that prefer a fully activated preparation. We believe a well rounded “full spectrum” preparation should contain a small percentage of Cannabinoids in their acid form. This is why we prefer to use this particular infusion as a “carrier” oil to be blended with fully activated Cannabis Oil (Part #1) to fill custom capsules or syringes (Part #3).

One of the biggest advantages in using the pressure cooker over other methods (slow cooker etc.) is the material will not scorch, even with the higher temperatures obtained cooking under pressure. In our opinion, burning or scorching an infused oil ruins it. Many believe ingesting scorched oil causes irritation within the G.I tract (i.e. upset stomach, nausea, and loss of appetite). Coconut oil has a smoke point of 350 degrees F. Pure Cannabis oil that has been filtered properly has a smoke point right around 295 degrees F. Temperatures inside the pressure cooker will top out at around 250 F.

The water in the recipe creates super hot steam and most importantly, provides a buffer between the Cannabis and the heat source. However, when an infusion is subjected to the same temperatures in a slow cooker without water it can easily scorch. If water is simply added to the slow cooker, the H2O will boil at 212 degrees preventing the overall temperature from rising high enough for sufficient decarboxylation to occur. It is not the coconut oil or the plant resin that scorches, it is the residual plant waxes, proteins and chlorophyll within the extraction. These materials will scorch at much lower temps than pure oils, especially if there is not a water buffer utilized during the extraction process. The pressure cooker allows the material to reach higher temperatures via steam and high pressure, providing a gentle yet thorough extraction of Cannabinoids with a higher overall decarboxylation without scorching.

Note: We will be removing the bulk of the undesirable constituents (waxes and and proteins) after the infusion returns to a solid state.

Necessary Supplies:

• 35 Grams High Grade Cannabis

• 35 liquid oz. Organic Unrefined Coconut Oil

• 1 and One half qt. R/O or Distilled Water

• 6 qt. Pressure Cooker

• 6 qt. Stainless Pot (same in Part #1 last issue)

• 8 Inch Stainless Steel Strainer (same in Part#1 last issue)

• 1 White Cotton “Potato Sack” Dish towel cut into quarters (same in Part #1 last issue)

• 1 qt Mason Jar

• 3 Pint Mason Jars with Lids

• Rubber Spatula

• Stove and Refrigerator

• Cold Water for Rinsing

Preparation:

To begin, work the DRY Cannabis buds (or resin coated trimmings) through the 8 inch stainless screen strainer (work through with fingers), if the material is too gummy or sticky spread it onto a cookie sheet and place it in the oven at 200 degrees for 10 minutes or so, just enough to drive excess moisture out of the bud/ trim and make it nice and brittle. Discard seeds and stems…

Be certain all jars, lids, pots and dishtowel (straining cloth) are thoroughly washed and sanitized. Just as you would with any other canning process. Cut the dish towel into 12 inch by 12 inch squares and stack two layers into the strainer over the stainless pot. As far as material quantities are concerned, simply remember 35 grams Cannabis to 35 liquid oz. of Coconut Oil, and a 1 to 1.5 ratio of oil to water…..Simple!

Extraction:

Gently melt the coconut oil in a warm water bath, fill the quart mason jar all the way to the top (35 liquid oz.) then empty into the pressure cooker. Add three pints (1 and ½ qt.) Distilled or filtered R/O water (it is important to use a pure water source as we do not want any hard water deposits or chlorine in our final product). Finally, add the prepared Cannabis. Place the cover on securely and set the cooker on the stovetop on medium heat, be sure that the flame is medium (small yellow tips) and NOT high.

If the flame is too high too much water will boil off over the 90 minutes and the infusion will be liable to scorch. At the end of the cooking time there should be about 15-20% water left overall, this is very important as the ratio between water and oil needs to be just right for proper separation between the two during the cleaning and rinsing stage (more on this later). When the cooker begins to rattle and hiss begin timing. Cook for a full 90 minutes, turn off the flame and allow the cooker to cool for 10 minutes. At this point the cooker can be moved into the kitchen sink and a very small stream of cool water can be run onto the lid. This will allow the cooker to depressurize in about 5 minutes enabling the lid to be safely removed.

Straining:

When the solution is cool enough (but not cold) to handle safely, pour the entire contents through the prepared strainer, cloth and into the stainless pot. Let the strainer drain and cool for a full 20 minutes. Bring up the edges of the dishcloth, twist and squeeze out (over the strainer) as much of the solution as possible. If it is too hot on your hands at this point, use a set of tongs. After squeezing, discard cloth and extracted material. Have three clean and sterile pint jars and lids ready. Briskly stir the solution in the pot to temporarily emulsify the oil and water, immediately pour into the three jars equally. Tightly fasten the lids and flip the jars upside down. Let the oil and water separate at room temperature for 15 minutes, then gently move the jars (keep upside down) into the refrigerator and allow to solidify (12 hours).

De-Waxing, Rinsing and Storage:

These are the most important steps in the process of making a high quality infusion that resists spoilage and one that is also gentle and nourishing on the body (i.e G.I tract).

This is considered a “full-extract” infusion so there will be some plant constituents other than pure resin that can be prone to spoilage if not removed. Fortunately when we allowed the jars to rest at room  temperature all the ‘nasty’ stuff was left to congregate and separate out of the infusion between the water and clean infused oil!

After 12 hours in the refrigerator the jars can be held over the sink while the lids are pried off releasing the red-tinted water down the drain. What you will see under the water is the “nasty layer” primed for removal with a small spoon. This layer will be approx. 1cm thick and will scrape and rinse out easily. Use a sink sprayer to rinse out any remaining gunk after scraping. This gunk is all the plant residues (other than resin) that are prone to spoilage and mold. Good riddance!

The final step in making a pure and stable infusion ready for use or storage is the removal from the pint jar and thorough rinsing under clean COLD water. This step must be executed just right in order to limit the amount of finished oil being wasted. We need to heat the outside of the jar JUST ENOUGH to allow the block of solid oil to slide out of the pint jar for rinsing.

To do this, place an empty pint mason jar upright into the bottom of a clean cooking pot, add enough water (about 3 inches) around the jar to fill it up to the bottom of the jars threads.

Remove the jar, place the pot on medium heat and bring the water temperature up to exactly 120 degrees F. Use a thermometer to make certain it is at the 120 degrees. Place a full pint jar (one at a time, with the wax layer removed and the lid off) into the warm water. Allow the jar to set in the warm water for exactly 30 seconds ! Remove from the warm water bath and immediately shake the block of infused oil over the kitchen sink out into your hand while holding under the flow of COLD water from the tap. It will have a slight suction so vigorous shaking may be necessary. If it just will not shake out then put it back into the water bath for an additional 10 seconds and try again. Catch the block and immediately rub/rinse for a full 30 seconds with the COLD water running continuously. It will feel a bit greasy for the first few seconds under the flowing water but will quickly harden into a lovely, super clean block of perfection!

Pat dry the block with a paper towel. The infused block of coconut oil is now ready for short or long-term storage, or to be used in your favorite recipe as-is ! The best option for long term storage is to place two “pint” blocks into a clean and sterile qt.mason jar and place in the freezer. You may also slide a single block back into a clean pint mason jar and place it into the refrigerator for easy access. The infusion will keep for up to 30 days worry free in the fridge. Do however use a quart jar for freezer storage as the air space around the blocks will prevent the glass jar from breaking from expansion caused by freezing.

The finished blocks of infused oil will smell amazingly clean, pure and void of any “off” smells or flavors that come with a batch that has either been scorched or not properly rinsed and de-waxed. Do yourself a favor and pop a small chunk of the finished oil into your mouth, savor the delicate nutty flavor as it gently melts and coats your taste buds with wonderful subtleties only these two incredible ingredients can create together. Organic Coconut oil and Organic Cannabis….Oh, life’s simple pleasures!

Relevant Notes and Considerations:

When using the infused oil in your favorite recipe(s), simply substitute ALL fats by volume with the coconut oil…..it is FAR superior in overall quality than butter, margarine or shortening and will produce an exceptionally light and delicately flavored treat. It can also be creamed and whipped, just like softened butter. You WILL NOT be able to tell that your finished baked good is loaded with Cannabinoids. This extraction is so pure, your finished product will look, smell and taste very much like the non-medicated version.

Remember to start small when it comes to edibles and allow a full 2 hours to feel the effects of the Cannabinoids after ingestion, especially if you are unaccustomed to ingesting Cannabis. People’s digestion varies greatly but the average onset is 60 to 90 minutes. The high can be quite intense for certain individuals and should always be used with caution. Please keep infusions and medicated baked goods at a safe distance from children and pets.

Our favorite way to enjoy the infused oil is simply spooning straight from the jar out of the refrigerator! Absorption via sublingual administration certainly has its advantages. The onset of the high will happen faster than relying on digestion and the duration will be shorter overall. It is also much easier to titrate and manage successive doses. However you choose to ingest it, enjoy this very simple, versatile and delicious Cannabis infused treat!

Stay tuned for the final installment of this series on Homemade Cannabis Medicine. In Part 3 we will wrap the series up by blending together the Pure Cannabis Extract from Part 1 into the Infused Coconut Oil, crafting capsules and oral syringes on a fully customizable basis!

To Your Health!

Nugs and Nurse Tori

Originally published in Weed World Magazine issue 116